Bergeon 6499 Jig Vise Miter Cutter Swiss Made
Jig Vise Miter Cutter * Top Quality Tool Steel * Made in Switzerland * For making perfectly flat cuts of 90 or 45 degrees
The Bergeon Swiss made jig vise miter cutter could be your favorite tool on your bench! Made of super hard tool steel rated at 58 HRC, this 1-7/8" X 2-3/4" tool holds stock up to 1/2" thick so you can file perfectly flat 90 degrees or 45 degree cuts on tubing, wire and sheet. The lower opening is for making 90-degree cuts; the upper opening holds your stock for making 45-degree cuts. There is 34mm distance between the small integrated stop along both the flat 90 degree slot and the 45 degree slot to the edge of the tool so you can hold and cut a flat piece of sheet up to that 34mm length.
Can be mounted in a vise or held in the hand. Saw or file against this vise and PRESTO, a perfectly flat surface.
Supplied with an adjustable stop for making repeat cuttings of the same length, and a hex key for fixing the stop.
Warning: Certain files including Glardon-Vallorbe Valtitan files are as hard or harder than the jig vise miter cutter. In that case they will mark the vise. Strong force with just about any file will mark the vise. Marks made on the vise are not an indication of a defect but only that the tool being used against the vise is harder than the tool itself.